Starting The Memory; Changing The Signal Duration; Care And Cleaning; Cleaning Agents - Siemens HF15M251 Instrucciones De Uso

You can save the memory settings and start the appliance
■
immediately. When finishing, instead of pressing
"start".
Saving a new setting in the memory: press the
■
The old settings appear. Save the new programme as
described in steps 1-4.

Starting the memory

It is very easy to start the saved programme. Place your meal
into the appliance. Close the appliance door.
Press the i button.
1.
The saved settings are displayed.
Press the start button.
2.

Changing the signal duration

You will hear a signal when the appliance is switched off. You
can change the duration of the acoustic signal.
Press the "start" button for approx. 6 seconds.

Care and cleaning

With careful care and cleaning your microwave oven will retain
its looks and remain good order. We will explain here how you
should care for and clean your appliance correctly.
:
Risk of short circuit!
Never use high-pressure cleaners or steam cleaners to clean
the oven.
:
Risk of burns!
Never clean the appliance immediately after switching off. Let
the appliance cool down.
:
Risk of electric shock!
Do not immerse the appliance in water or clean under a jet of
water.
Surfaces are different, and damage caused by using the wrong
cleaning agent can be avoided by observing the information in
the table below.
Do not use
sharp or abrasive cleaning agents.
■
The surface could be damaged. If such a substance comes
into contact with the front of the appliance, wash it off
immediately with water.
metal or glass scrapers to clean the glass in the appliance
■
door.
metal or glass scrapers for cleaning the seal.
■
hard scouring pads or cleaning sponges.
■
Wash new sponge cloths thoroughly before use.
cleaning agents with high concentrations of alcohol.
■

Cleaning agents

Caution!
Before cleaning, unplug the appliance from the mains or switch
off the circuit breaker in the fuse box. Clean the outside of the
appliance and the cooking compartment with a damp cloth and
mild detergent. Dry with a clean cloth.
24
The cooking time counts down in the display.
, press
i
The cooking time has elapsed
A signal sounds. Open the appliance door or press Stop. The
button.
i
clock reappears.
Pausing
Press the Stop button once, or open the appliance door. After
closing, press the Start button again.
Cancelling the setting
Press the Stop button twice, or open the appliance door and
press the Stop button once.
The new signal duration is adopted.
The clock reappears.
The following are possible:
Short signal duration - 3 tones
Long signal duration - 30 tones.
Area
Appliance front
Appliance front
with stainless
steel
Cooking com-
partment made
of stainless steel
Recess in cook-
ing compartment
Turntable and
turntable ring
Door panels
Seal
Cleaning agents
Hot soapy water:
Clean with a dish cloth and dry with a soft
cloth. Do not use glass cleaners or metal or
glass scrapers for cleaning.
Hot soapy water:
Clean with a dish cloth and dry with a soft
cloth. Remove flecks of limescale, grease,
starch and albumin (e.g. egg white) immedi-
ately. Corrosion can form under such resi-
dues. Special stainless steel cleaning agents
can be obtained from the after-sales service
or from specialist shops. Do not use glass
cleaners or metal or glass scrapers for
cleaning.
Hot soapy water or a vinegar solution:
Clean with a dish cloth and dry with a soft
cloth.
If the oven is very dirty: use oven cleaner,
but only when cooking compartment is cold.
It is best to use a stainless-steel sponge. Do
not use oven spray or other aggressive oven
cleaners or abrasive materials. Scouring
pads, rough sponges and pan cleaners are
also unsuitable. These items scratch the sur-
face. Allow the interior surfaces to dry thor-
oughly.
Damp cloth:
Ensure that no water seeps through the turn-
table drive into the appliance interior.
Hot soapy water:
When putting the turntable back in place,
make sure it slots in correctly.
Glass cleaner:
Clean with a dish cloth. Do not use a glass
scraper.
Hot soapy water:
Clean with a dish cloth, do not scour. Do not
use a metal or glass scraper for cleaning.