Power Switch - Vox MVX150C1 Manual De Usuario

5-1. POWER LEVEL
This 6 way selector decides the total output volume. MUTE position disables the power amp, so that you can
do a silent recording with the EMULATED LINE OUT.
5-2. IMPEDANCE
Please select the same value as the impedance of the speaker cabinet you use.
(MVX150C1 internal speaker is 4ohm)
5-3. WET ONLY SPEAKER OUTPUT
You can get only the WET signal from this speaker output, when using EFFECT LOOP or REVERB. Con-
necting to this jack makes the standard speaker output DRY automatically, so that you can achieve the pro-
fessional DRY/WET setup very easily.
This output is independent from the standard speaker output. Minimum load is 4ohms.
If you use the WET ONLY OUTPUT, the total output wattage will be switched automatically.
For example, when you plug the speaker cabinet into both DRY and the WET ONLY OUTPUT, the maximum
output wattage will be limited to 75W for DRY, and 75W for WET.
NOTE! Speaker jack does not need to be used if not required. This won't harm the amp.
NOTE! This is BTL (Bridge-Tied-Load) output. This means both tip and sleeve is the signal line, and sleeve is
not grounded. Only use this jack for connecting speakers to MVX150. Connecting anything else may result in
damages to MVX150.
WARNING! To ensure that your system works correctly, you must observe the following points.
a) Don't connect a speaker whose rated input capacity is less than the total output wattages. The speaker
may be destroyed if you ignore this caution—not recommended!
b) You must use a speaker cable to connect an external speaker. Don't use a shielded cable like the one
you use to connect a guitar to an amp.
c) You must turn off the power before connecting the speaker cable. Connecting the cable while the power
is turned on may damage your amp.
NOTE! It is recommended that all audio cables (with the exception of the speaker lead), used to connect to
the MVX150C1/MVX150H are of a high quality, screened type. These should not exceed 10 metres in length.
6. ECO switch
This switch decides the setting of ECO mode and LED mode.
ECO=ON enables the auto power-off function.
LED=ON turns the LED illumination on.

7. Power switch

Hold this switch, to turn the amp ON, or STANDBY (OFF).
8. MAINS INPUT
Connect the included power cord here.
WARNING! Be sure to plug the power cord into an outlet of the appropriate voltage.
WARNING! Use only the included power cord. Using any different power cord may cause malfunctions or
other issues.
8