Auto Power-Off Function; Specifications - Vox MVX150C1 Manual De Usuario

Auto power-off function

The amp has an auto power-off function. With this function, the amp is automatically turned off if there is no output
for approximately 30 minutes.
When the amp is turned off, it is not turned back on, even if a control is operated. After the amp is turned off, turn it
on again.
NOTE! When the input level is extremely low or there is very little change in the sound, the auto power-off function
may be activated. In addition, depending on the settings and environment, the amp may interpret noise as input,
even if the guitar is not being played.
TIP! As the factory default setting, the auto power-off function is enabled (ECO SW=ECO: ON). The function can
be disabled by moving the ECO switch to the ECO: OFF position.
Over load protection function
This amp has an over load protection function for its safety.
The power amp will be disabled, if the speaker output was shorted, or had some trouble with an impedance of the
speaker cabinet you connect. Moreover, the amp will be shut down when the total output wattage exceeds 150W.
With these cases, please check the connection or the impedance of the speaker cabinet you connect, and re-start
the amp.

Specifications

Input/Output jacks:
Power amp output:
Speaker:
Current consumption:
Dimensions (WxDxH):
Weight:
Included items:
Options:
* Specifications and appearance are subject to change without notice for improvement.
INPUT, SEND, RETURN, EMULATED LINE OUT, SPEAKER OUTPUT
(MVX150H: 2x SPEAKER OUTPUT, MVX150C1: EXTERNAL), WET ONLY
SPEAKER OUTPUT
Maximum approx. 150W RMS@4ohms, 75W RMS@ 8ohms, 37.5W
RMS@16ohms
MVX150C1: 1x 12" 4ohm Celestion G12H-150 Redback
300W
MVX150C1: 520 mm x 260 mm x 535 mm / 20.47" x 10.24" x 21.06"
MVX150H: 520 mm x 219 mm x 194 mm / 20.47" x 8.62" x 7.64"
MVX150C1: 19.4 kg / 42.77 lbs.
MVX150H: 7.1 kg / 15.65 lbs.
Power cord, Owner's manual
VFS2A Footswitch, VFS2 Footswitch
9