Publicidad
Idiomas disponibles
Idiomas disponibles
HOW TO USE
THE WHEEL
LOCKOUT
Each wheel is secured to the axle with
a lockout pin. See Figure 15. The unit
was shipped with the lockout pin in the
locked position. For ease of maneuver-
ability, disconnect the lockout pin as fol-
lows.
1. Pull the knob out to disengage the
lockout pin.
2. To lock in the disengaged
position,
turn the knob 1/4 turn (90 degrees).
Knob
Wheel Lockout
Figure15
HOW TOUSE THE HEATED
GRIPS
,_
WARNING:
Heated grips are
designed for use when the tem-
perature is below 32 degrees.
Do not turn on electric grips if tempera-
ture is above 32 degrees.
When the temperature falls below 32 de-
grees, use the heated grips to keep your
hands warm. Move the heated grip switch
to the ON position (see Figure 14). It will
take a couple of minutes for the grips to be-
come warm. Because heated grips can be-
come very warm, we recommend that you
wear gloves. If you notice that the grips are
too warm, turn off heated grips.
BEFORE STARTING THE ENGINE
1. Before you service or start the en-
gine, familiarize yourself with the
snow thrower.
Be sure you under-
stand the function and location of all
controls.
2. Check the tension of clutch cable
before starting the engine.
See To
Adjust
The Control
Cable para-
graph in the Service & Adjust-
ments section of this manual.
3. Be sure that all fasteners are tight.
4. Make sure the height adjust skids
are properly adjusted.
See To Ad-
just Skid Height paragraph in the
Service & Adjustments
section of
this manual.
5. Checktire
pressure (14-17
pounds).
Do not exceed maximum
amount of pressure.
CHECK THE OIL:
NOTE: The engine was shipped from
the factory filled with oil. Check the lev-
el of the oil. Add oil as needed.
F-031068L
TO Add Oil
1. Make sure the unit is level.
NOTE: Do not check the level of the
oil while the engine runs.
2. Remove the oil fill cap/dipstick.
Check the oil.
3. If necessary, add oil until the oil
reaches the FULL mark on the oil fill
cap/dipstick (see Figure 16). Do not
add too much oil.
OII Fill Cap/Dipstick
FULL
15
NOTE:
Oil level must be
between Full and Add mark
Figure 16
4. Tighten the fill cap/dipstick securely
each time you check the oil level.
NOTE:
S.A.E. 5W30 motor oil may be
used to make starting easier in areas
where temperature
is consistently 20°F.
or lower.
Publicidad
