Amate Audio TPD Manual De Usuario página 19

TPD
6.2.5 Dynamics Compressor [only in Admin mode]
A true RMS compressor can be set to avoid the input signal go above a certain RMS
value. The following parameters can be adjusted:
• Thr. - Compressor Threshold. Sets the level at which the compressor will activate.
• Att. - Attack time. Time it takes the compressor to start actuating after reaching the
threshold.
In LR Compr.:
Thr.: 24.00dBu
• Hold - Hold time. Sets up a delay before the compressor enters the release cycle.
Useful for compressing low frequency long notes.
• Rel. - Release time. Time the compressor uses to return to unity gain after the
signal is below the threshold.
In LR Compr.:
Hold: 10ms
• Ratio - The compressor ratio determines the slope in which the signal is
compressed. The higher this value is, the higher the compression.
• Gain – The compressor make up Gain. Use it in case the level of the compressed
signal must be corrected (0dB by default)
In LR Compr.:
Ratio: 5.00:1
6.2.6 Limiter
A peak-limiter can be set at each input. It is a zero attack time limiter, so it will
immediately act on the signal. The parameters that can be changed are:
• Thr. – Threshold: input level at which the signal will be limited.
• Rel. – The release value, expressed in dB/seconds [only in Admin mode]
In LR
Name
Thr.: 12.00dBu
6.2.7 Channel Link
Input channels L and R can be linked in order to set the same parameters on both.
The factory setting is that channel L and R are linked. Turn the rotary knob set the
link off.
In LR Link:
On
19
Limiter
In LR Compr.:
Att.: 20ms
In LR Compr.:
Rel.: 200ms
In LR Compr.:
Gain: 1.00dB
In LR Limiter
Name
Rel.: 50
Jul 2016
Amate Audio