Channel Link - Amate Audio TPD Manual De Usuario

TPD
• Freq - EQ center frequency.
• Gain - EQ level gain.
OutL2 PEQ 1
Freq: 1000Hz
• Q - EQ Bandwidth. For shelving filters the Q sets the transition in dB/Oct.
• Type - Shape of EQ. The available types are:
Bell: Modifies the gain of a certain frequency range, with bell shape
Notch: Eliminates a range around a center frequency
High-Shelf: Modifies the gain of all the range above a selected frequency.
Low-Shelf: Modifies the gain of all the range below a selected frequency.
All Pass: Modifies the phase response, without influencing the frequency response.
Band Pass: Filters out all the range except the defined band.
High Pass: Filters out all the range below a certain frequency.
Low Pass: Filters out all the range above a certain frequency.
OutL2 PEQ 1
Q: 2.36
6.3.6 Limiter [see Table 4]
A peak-limiter can be set at each input. It is a zero attack time limiter, so it will
immediately act on the signal. The parameters that can be changed are:
• Thr. – Threshold: input level at which the signal will be limited.
OutL2 Limiter
Name
Thr: +7.50dBu
6.3.7 Phase – Phase inversion
Change the polarity of the channel by a 180º phase inversion. Select between
Normal or Inverted.
OutL2 Phase:
Normal

6.3.8 Channel Link

Output channels can be linked in order to set the same parameters on both. Turn the
rotary knob set the link off.
For Amate presets, this is only available in Admin mode.
OutL2 Link:
On
22
OutL2 PEQ 1
Gain: 0.00dB
OutL2 PEQ 1
Type: Bell
Jul 2016
Amate Audio