MAINTENANCE
UNCLOGGING THE EXTRUDER
Use the unclogging tool to clean the extruder and
unclog built up filament, fig 9.
1. Click on the filament change button on the screen
and wait for extruder to heat up. As filament starts
to purge, insert the unclog tool into the extruder
intake (top).
2. Clogged debris will be pushed down and will
extrude from the extruder tip. You should push the
unclog too all the way down to ensure all filament
is purged. You do not need to push with excessive
force, as this may damage the extruder.
UPDATING FIRMWARE VIA NETWORK
If your 3D45 is connected to WiFi, it should check for
firmware updates each time it boots up. You can also
update its firmware directly from the touchscreen. To
update firmware:
1. Tap "Tools", then tab "Updates".
FIG. 9
2. Your 3D45 will check to see if it has the latest
firmware installed and ask if you would like to
update if one is needed.
3. Choose accept to download and install the latest
firmware.
4. When the 3D45 starts up and returns to the Home
Screen, firmware update is complete.
32
W
W
A
P
U
(
p
p