Using The Camera; Best Practices - Dremel 3D45 Manual De Instrucciones

USING THE CAMERA

Your 3D45 is equipped with a camera that can be used
to remotely monitor prints as long as your printer is
connected to a network. There are two ways to access
the camera: through the Dremel Digilab 3D Slicer (see
page 438) or directly via a web browser.
DIRECT THROUGH WEB BROWSER
1. Make sure the device you want to view the camera
on is connected to the same network as the 3D
printer. This could be via Wi-Fi or via Ethernet.
2. On the main menu of your 3D45 tap "Tools"
3. In the tools menu tap "About"
Locate the IP address of your printer. If your printer
is connected to the network via Ethernet, this is the
address next to "Ethernet IP". If it is connected via
Wi-Fi this is the address next to "WiFi IP". It will be
a sequence of three or four numbers separated by
dots.
DREMEL DIGILAB 3D45
FIRMWARE VERSION V1.0
USAGE COUNTER: 000
PRINTER STATUS: XXXX
ETHERNET MAC: 00:00:00:00:00:00
WIFI MAC: 00:00:00:00:00
ETHERNET IP: 000.000.000.000
NETMASK: 000.000.000
GATEWAY: 000.000.000.000
DNS: 000.000.000.000
4. Open any web browser on the device you want to
view the camera on.
5. In the address bar, enter the string:
http://IPADDRESS:10123/stream_simple.html
For example,
http://000.000.000.000:10123/stream_simple.html
6. Press enter and you will see a screen with a view
of the camera as below.
1. ALWAYS USE PROVIDED GLUE STICK.
2. Ensure your build platform is level before every
print.
3. For proper adhesion of filament to the build
platform, regularly wash the glue from the build
platform with warm water, dry the build platform,
re-apply a fresh layer of glue and re-level.
4. Ensure spool is installed properly and can rotate
freely.
5. When using your Dremel 3D45 for the first time
or after changing filament, allow Dremel 3D45 to
extrude until material is consistent with the installed
filament color.
6. It is important to watch your Dremel 3D45 begin
building objects. Your object is most likely to
experience difficulty in the beginning. Thankfully,
this is also the most convenient time to cancel
the object, clean the build platform, and start your
object again. Remain near the Dremel 3D45 during
the building process.
7. It is important to save your Dremel 3D45 packaging
as it will make re-boxing and transporting your
Dremel 3D45 easier.
8. Ensure that you store filament spools in an
environment that is not moist or too hot. It is
!
recommended that you do not remove the filament
spool from its airtight packaging until use.
9. Use object removal tool gently to avoid damaging
the build platform or object.
10. Whenever possible, it is best to locate your object
in the center of the build platform. Using the best
orientation for your object is critical. Ensure that
LICENSE
your object is located on the build platform and that
you are using the best orientation for building.
11. For steep overhangs (Less than 45 degree angle) it
is recommended to build with support.
12. Always remove the build platform before removing
the object.
450

BEST PRACTICES