10.1.2.2 Defining the lighting conditions
(RATIO) for the flash groups on the
master flash unit
+
Lighting condition control (ratio) is only
possible in CTRL+ mode.
The slave flash units must be working in TTL
mode.
The lighting conditions of the remote system
REMOTE
M
can be set to achieve particular lighting
CTRL +
1/16
effects. The lighting conditions for the master
CTRL RMT RMT2
(CTRL) and the groups (RMT, RMT2) are con-
1 1
1
trolled exclusively via the master flash unit.
• Press the
INFO
RATIO
touch display.
CTRL
1
• Press the sensor button on the touch
RMT
1
display for which a lighting condition is to
RMT2
be set, in the example RMT2.
1
• Press the sensor buttons
2
the touch display set the desired lighting
4
condition or switch off the lighting
8
contribution (--).
• Press the sensor buttons on the touch
display for the desired correction value.
REMOTE
M
CTRL +
1/16
The setting is applied immediately.
CTRL RMT RMT2
1 1
4
INFO
RATIO
RATIO
sensor button on the
on
10.1.3 Remote channel settings
There are four independent remote channels
to use so that multiple remote systems in the
same room do not interfere with one another.
Master and Slave flash units belonging to the
same remote system must be set to the same
remote channel.
D
• Press the
for the selection menu to appear.
• Press the
touch display.
ZOOM
• Press the
touch display and select "CHANNEL".
CHANNEL
CHANNEL
• Press the
RATIO
touch display.
1
• Press the
touch display and select the channel.
CH
2
• Press the sensor button on the touch
3
display for the desired channel.
The setting will take effect immediately.
The channel setting can be checked by
pressing the sensor button
button as often as it takes
PARA
sensor button on the
sensor buttons on the
sensor button on the
sensor buttons on the
INFO
.
163
k