Light Switch; Battery Installation - Sony VPL-S800U Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

!∞ LIGHT switch
Lights the back lighting for the keys on the Remote
Commander. Press again to turn off the back lighting.
If you do not press any key for 30 seconds, back
lighting turns off automatically.

Battery installation

1
Push and slide to open the lid.
2
Install the two size AA (R6) batteries (supplied)
with the correct polarity.
Be sure to install
the battery from
the ' side.
3
Replace the lid.
Notes on batteries
• Be careful that the battery orientation is correct when
inserting batteries.
• Do not mix old battery with new one, or different
types of batteries.
• If you do not intend to use the Remote Commander
for a long time, remove the batteries to avoid damage
from battery leakage. If a battery has leaked, remove
the batteries, wipe the battery compartment dry and
replace the batteries with new ones.
Notes on wireless Remote Commander
operation
• Be sure that there is nothing to obstruct the infrared
beam between the Remote Commander and the
projector.
• The operation range is limited. The shorter the
distance between the Remote Commander and the
projector, the wider the angle within which the
commander can control the projector.
• The remote control detectors on the projector do not
operate when connecting the remote commander
cable to the CONTROL S IN jack. If you wish to use
the Remote Commander as a wireless Remote
Commander, be sure to remove the remote
commander cable from both the Remote Commander
and the projector.
To connect the Remote Commander to the
projector
Rear
CONTROL S
REMOTE
IN
OUT
RS-422A
PLUG IN
POWER
S VIDEO
VIDEO
AUDIO IN
Y IN
C IN
IN
OUT
IN
OUT
L
R
(MONO)
AUDIO OUT
L
R
to CONTROL S IN
Stereo remote
commander cable
(supplied)
Note on wired Remote Commander operation
using the supplied stereo remote commander
cable
If the MOUSE/MENU switch is set to MENU to
operate the projector, you do not need to install the
batteries since the power is supplied from the
CONTROL S IN jack on the projector. In this case, the
batteries are not consumed.
INDEX
TRIG
0
0
INPUT A
R/R-Y
G/Y
B/B-Y SYNC/HD
VD
AUDIO IN
L
R
(MONO)
REMOTE 1
MODE
IN
OUT
Remote Commander
to CONTROL
S OUT
15
(EN)

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Vpl-s800m

Tabla de contenido