Sony VPL-S800U Manual De Instrucciones página 20

Projecting
20
(EN)
VIDEO: Selects the video signal input from the VIDEO or S
VIDEO connectors and the audio signal input from the
AUDIO IN L/R jacks. To switch the VIDEO or S VIDEO
connectors, use the SELECT key.
SELECT:Each time you press this key, the input signal is switched
between VIDEO and S VIDEO.
A: Selects the audio and video signals input from the INPUT
A connectors.
B: Selects the signal input from the connectors on the optional
interface board (other than IFB-40) which is installed in the
INPUT B section.
When you input the signal from equipment connected to the
signal interface switcher, set the SWITCHER/INDEX/LENS selector
on the Remote Commander to the SWITCHER position and designate
the channel number by pressing the number keys.
4
Set the SWITCHER/INDEX/LENS selector to the LENS position, and
then press the PATTERN key on the Remote Commander or the
control panel to display the HATCH pattern.
Press the PATTERN key again to clear the HATCH pattern.
5
Press the FOCUS +/– key on the Remote Commander or the control
panel to adjust the focus.
"FOCUS" appears on the screen during adjustment.
Note
If the VPLL-FM20 or VPLL-FM30 optional lens is installed, you
cannot adjust the focus using the FOCUS keys. In such case, adjust the
focus using the focus ring of the lens.
6
Press the ZOOM +/– key on the Remote Commander or the control
panel to adjust the zoom.
"ZOOM" appears on the screen during adjustment.
Note
If the VPLL-FM20 or VPLL-FM30 optional lens is installed, you
cannot adjust the zoom.
7
Press the FOCUS +/– key on the Remote Commander or the control
panel again to adjust the focus.
"FOCUS" appears on the screen during adjustment.
optional