Troubleshooting; Service Information - OHAUS Ranger 1000 Serie Manual De Instrucciones

EN-12
8. MAINTENANCE
8.1 Cleaning
CAUTION: Disconnect the Ranger 1000 Scale from the power supply before
cleaning.
The housing may be cleaned with a cloth dampened with a mild detergent if
necessary.
Attention: Do not use solvents, chemicals, alcohol, ammonia or abrasives to clean
the housing or control panel. Do not allow liquids to enter the housing.
8.2

TROUBLESHOOTING

The following table lists common problems, possible causes and remedies. Should
further problems persist, please contact your local servicing dealer.
Symptom
Scale will not turn on
Battery fails to charge
fully
Weight reading does
not stabilize
Scale does not display
accurately
E1 error code displayed EPROM data loss.
E2 error code displayed
E3 error code displayed
8.3

Service Information

If the troubleshooting section does not resolve or describe your problem,contact your
authorized OHAUS service agent. For service assistance or technical support in the
United States call toll-free 1-800-526-0659 between 8:00 AM and 5:00 PM EST. An
OHAUS product service specialist will be available to provide assistance. Outside the
USA, please visit our web site,www.ohaus.com to locate the OHAUS office nearest
you.
Possible Causes
AC power not connected.
Battery discharged.
Battery defective or past
its useful life.
Unstable environment.
Interference under pan.
Improper calibration.
A/D count is not correct.
Display capacity
exceeded
RANGER 1000 SERIES
Remedy
Connect scale to power.
Replace battery by an
authorized service dealer.
Ensure a stable
environment.
Ensure that the weighing
pan is unobstructed and
free to move.
Calibrate the scale using
proper calibration weights.
Replace the scale.
Have the load cell replaced.
Ensure display capacity is
not exceeded