Impecca IWA-15KSFP Manual De Usuario página 12

WInDoW MoUnTInG (ConTInUeD):
Top
View
3. Insert top and bottom legs of window
filler panel frame into channel in the
top angle and bottom rail. Do both
sides.
4. Insert washer head locking screws
(2) into holes in top leg of filler panel
frame (see step 6). Do not totally tigh-
ten. Allow leg to slide freely. Screws
will be tightened after section 6.
Install Top Angle and
4
Side Bracket
1. Open window and mark center of window stool.
2. Place cabinet in window with bottom stool angle
firmly seated over window stool as shown. Bring
window down temporarily behind top angle to
hold cabinet in place.
Stool
Air Conditioner
Plastic
Cabinet
Frame
Locking
Screw
I Section
Hole
Window
Filler
Panel
Stool
Angle
3. Shift cabinet left or right as needed to line up
center of cabinet on center line marked on stool.
4. Fasten cabinet to window stool with 2 screws
into holes(You may wish to pre-drill pilot holes).
5. Add bottom rail seal over screws to window stool.
5 Install Support Bracket
1. Hold each support bracket flush against
outside of sill, and tight to bottom of cabinet
as shown below. Mark brackets at top level
of sill, and remove.
2. Assemble sill angle bracket to support
brackets at the marked position, as shown.
Hand tighten, but allow for any changes later.
Mark
Left
Locknut
Sill Angle
Bracket
Flat Head
Bolt
2 Each Required For
Each Support Bracket
10
13
Bottom
Rail Seal
3 4 (or1 /2 )Long
Hex-head Screw
1 2 Long Screws
And Locknuts
Right