Light Bulb Replacement - Sears Kenmore 363 Manual De Uso Y Cuidado

De dos puertas
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

LIGHT BULB REPLACEMENT
Electrical Shock Hazard
Before replacing a burned-out light bulb, either
unplug the refrigerator or turn off power at the
circuit breaker or fuse box.
NOTE: Moving the control to the OFF position
does not remove power to the light circuiL
FRESH FOOD COMPARTMENT--UPPER
LIGHT
1. Unplug the refrigerator
2. To align the control knobs properly, note the position
of each knob for proper reassembly, move both knobs
atl the way to the left, then pull them off.
Pin
._
Pin
3. To remove the light shield, pull it straight out.
After replacing with an appliance bulb of the same or
lower wattage, reinstall the light shield. Replace the
control knobs, move them to their previous settings and
plug the refrigerator back in.
FRESH FOOD COMPARTMENT--LOWER
LIGHT (on some models)
This light is located behind the top drawer or right above
the top drawer (depending on your model)
1. Unplug the refrigerator°
2_
1
°
If the light is behind the top drawer you will need to
remove the drawer and the shelf above it..To remove
the drawer see To Remove Storage Drawers in the
Shelves and Storage Drawers section..
To remove the shelf, first
remove any food on the
shelf. Then tilt the shelf up
at the front and lift it up and
out of the tracks
Grasp the bottom of
the light shield and pull it
forward and up.
After replacing with same size bulb, replace the
shield. If you cannot locate the correct bulb, see your
dealer.
5.
If the tight was behind the top drawer, you will need to
replace the drawer and the shelf above ito
To replace the shelf, raise the shelf front slightly and
engage the top hooks in the lowest large track slots°
Then lower the front of the shelf until it is level.
& Plug the refrigerator back in.
FREEZER
COMPARTMENT
Non-Dispenser
Models
1. Unplug the refrigerator
2. Remove shelf just below
light shield, (Shelf will be
easier to remove if it is
emptied first.)
3o Pull plastic light shield
toward you_ (It will bend
to free tabs from grooves)
4_ After replacing with same
size bulb, reinstall shield and shelf.,
Dispenser Models
Unplug the refrigerator.
Remove the ice storage
bin_
Remove the screw at top
of light shield..
After replacing with the
same size bulb, reinstall
shield and ice storage bin°
=
2.
3.
4.
26
Screw

Publicidad

Tabla de contenido
loading

Tabla de contenido