Maintenance And Service; General; Daily Maintenance; Trouble Shooting The Water Pump - Husqvarna TS70 Manual De Instrucciones

General

WARNING! The user must only carry out
!
the maintenance and service work
described in this manual. More extensive
work must be carried out by an
authorized service workshop.
To prevent accidental starting, the steps
described in this chapter must be
performed with the motor off and the
power cable removed from the socket, if
not otherwise stated.
Wear personal protective equipment. See
instructions under the heading "Personal
protective equipment".
The life span of the machine can be
reduced and the risk of accidents can
increase if machine maintenance is not
carried out correctly and if service and/or
repairs are not carried out professionally.
If you need further information please
contact your nearest servicing dealer.
• Always disconnect the power cable before carrying
out service.

Daily maintenance

General
• Check that the machine's safety equipment is
undamaged. See instructions in the section
"Machine's safety equipment".
• Clean the outside of the machine. Do not use a high
pressure washer to clean the saw.
• Do not use water to clean the motor and electric
cabinett.
• Open the blade guard. Clean both the inside and
outside, and close the blade guard.
• Loosen the conveyor cart's two collection trays, both
the rear and the front, and clean them.
• Loosen the water collecting tray and clean it.
Water tank
• Clean the inside of the water tank.
Wheel rims/runners
• Clean the wheel rims and runners.

MAINTENANCE AND SERVICE

Water distributor (strip)
• Remove the strip in the conveyor cart cutting slot in
order to clean under it. Slurry can collect in the cavity
under the strip. In case of insufficient cleaning, the
strip can fasten and it will be difficult to remove.
Water pump
• Run through the water system for a short period in
order to prevent hoses getting blocked with slurry.
WARNING! Never clean motor and
!
electric parts with water.

Trouble shooting the water pump

• Make sure the lead to the water pump is connected.
• Make sure the valve on the water pump is set to the
correct position.
Do the following if the water pump stops pumping
water
• Stop cutting.
• Shut down the machine and disconnect the power
plug.
• Remove the water pump.
Clean the water pump
• Unscrew the suction filter (1).
• Unsnap the partition wall (2) for further cleaning.
• Prise loose the pump impeller (3).
• Pull out the pump impeller (5) and shaft (4) and clean
the parts including the housing. Make sure the pump
impeller rotates freely and is clean all round.
3
5
4
2
1
–
English 23