Ma Chine´S Safety Equipment; General; Blade Guards; Power Switch - Husqvarna TS70 Manual De Instrucciones

General

WARNING! Never use a machine that has
!
faulty safety equipment! If your machine
fails any checks contact your service
agent to get it repaired.
Shut down the machine and disconnect
the power plug.
This section descr ibes the machine ' s safety equipment,
its purpose, and how checks and maintenance should be
carried out to ensure that it operates correctly.
Blade guar ds
WARNING! Never use the machine
!
without a guard nor with a defective
guard. Always check that the guard is
correctly fitted before starting the
machine.
It is not permitted to expose the blade
more than 180 degrees without
protection.
The b lade guard is designed to prevent parts of the blade
or cutting fragments from being thrown towards the user.
Chec k the blade guards
• Check that the guard over the blade is not cracked or
damaged in any other way. Replace when damaged.
P ower switch
The po wer switch should be used to start and stop the
machine.
Chec king the power switch
• Push the insert (1) down to release the lock and flip
the power switch (2) up to start the machine.
1
MA CHINE´S SAFETY EQ UIPMENT
2
• Flip the power switch down to stop the machine.
Check that the motor and the blade stop. Make sure
that the cutting blade can rotate freely until it is
completely stopped.
A defective power switch should be replaced by an
authorized service workshop.
Locking knob, conveyor cart (TS70)
The locking knob is used to lock the conveyor cart in place
when in transit.
Checking the locking knob, conveyor cart
• Make sure the locking knob is in position and that the
conveyor cart is locked.
Catch, support arm (TS90)
The catch locks the support arm and conveyor cart during
transport.
Checking the catch
• Make sure the support arm and conveyor cart are
locked when the catch is in position.

Water pump

WARNING! Submersible water pump. Do
!
not run dry. Must maintain grounding
properly. Risk of electric shock. The
pump may only be used together with the
products in this manual and shall be
used in accordance with the directions in
the manual.
–
English 7