General Guidelines - HQ-Power VDPL300QF2 Manual Del Usuario

• Do not switch the device on immediately after it has been exposed to changes in temperature. Protect the
device against damage by leaving it switched off until it has reached room temperature.
• This device falls under protection class I. It is therefore essential that the device be earthed. Have a
qualified person carry out the electric connection.
• Make sure that the available voltage does not exceed the voltage stated in the specifications of this manual.
• Do not crimp the power cord and protect it against damage. Have an authorised dealer replace it if
necessary.
•
Disconnect the device from the mains to clean it or when it is not in use. Handle the power cord by the plug
only.
• Do not look directly at the light source as sensitive people may go into epileptic seizure if they do.
• Keep the device away from splashing and dripping liquids. Never put objects filled with liquid on top of the
device.
• Note that damage caused by user modifications to the device is not covered by the warranty.
•
Mechanical wear and LEDs are not covered by warranty.
• Keep the device away from children and unauthorised users.

3. General Guidelines

Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.
• This device is designed for professional use on stage, in discos, theatres, etc. The VDP should only be used
indoors with the included power adapter connected to an alternating current of max. 230 VAC/50 Hz.
• Lighting effects are not designed for permanent operation: regular operation breaks will prolong their lives.
• Do not shake the device. Avoid brute force when installing or operating the device.
• Select a location where the device is protected against extreme heat (see "Technical Specifications"),
dust and moisture. Respect a minimum distance of 0.5 m between the device's light output and any
illuminated surface.
• Use an appropriate safety cable to attach the device (e.g. VDLSC7 or VDLSC8).
• Familiarise yourself with the functions of the device before actually using it. Do not allow operation by
unqualified people. Any damage that may occur will most probably be due to unprofessional use of the
device.
• Use the original packaging if the device is to be transported.
• All modifications of the device are forbidden for safety reasons.
•
Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks,
crash, etc. Using the device in an unauthorised way will void the warranty.
4. Features
• RGB-W colour beams
• with built-in programs for stand-alone mode and master/slave
• built-in microphone for sound-activation
•
DMX-controlled via 7 channels
• fast to slow strobe effect
5. Overview
Refer to the illustrations on page 2 of this manual.
1 DMX output
2 DMX input
3 Sensitivity knob
6. Installation
Choose a suitable mounting spot. Mount the fixture in the desired angle using the included bracket. Connect the
IEC power cord to the mains. Disconnect after use.
Mounting the device
• Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable norms.
V. 02 – 09/03/2012
VDPL300QF2
4 Built-in microphone
5 DIP switches
6 IEC cord input/fuse
3 ©Velleman nv