Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Safety • Installation
Important Safety Instructions
SAVE THESE INSTRUCTIONS - This manual contains
important instructions that should be followed during
installation, operation, and maintenance of the product.
Save this manual for future reference.
This is the safety alert symbol. When you see this
symbol on your pump or in this manual, look for one of
the following signal words and be alert to the potential
for personal injury!
indicates a hazard which, if not avoided, will
result in death or serious injury.
indicates a hazard which, if not avoided, could
result in death or serious injury.
indicates a hazard which, if not avoided, could
result in minor or moderate injury.
NOTICE addresses practices not related to personal injury.
Carefully read and follow all safety instructions in this
manual and on pump.
Keep safety labels in good condition. Replace missing or
damaged safety labels.
1. Read this manual carefully. Failure to follow these
instructions could cause serious bodily injury and/or
property damage.
2. Check your local codes before installing. You must
comply with their rules.
3. Connect the pump to a separate circuit with no
other appliances on the circuit. Consult a licensed
electrician for all wiring.
NOTICE: This pump does not require a connection to
a main stack vent, per the National Standard Plumbing
Code (NSPC) 2003 Section 11.7.9.
Description
This pump is designed to be used with a sink where a
gravity drain line is not available. Attach the pump to the
drain tail piece; the pump will start when water begins
to drain. Uses include basement laundry sinks, wet bars
and utility sinks.
Specifications
Power supply required. . . . . . . . . . . . . . . . . . . . . . . .115V, 60 HZ.
Liquid Temp. Range. . . . . . . . . . . . . . . . . 32° – 120°F (0° – 50°C)
Individual Branch Circuit Required (min.) . . . . . . . . . . . . 15 Amps
Pump Inlet. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-1/2" NPT
Pump Discharge . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-1/4" NPT
For parts or assistance, call Simer Customer Service at 1-800-468-7867
Installation
(See Figures 1 and 2)
Sink Bottom with Drain Port;
Tail Piece integral with Sink
A
1
2
For easier maintenance,
use 2 short sections of
pipe connected by a
1-1/2" Solvent Union.
3
1-1/2" Pump
Inlet Port
1-1/4" Pump
Discharge
Figure 1: Typical method of mounting the pump
Fittings Supplied
A
Sink drain screen
B
1-1/4" NPT x 1-1/4" slip check valve
C
1-1/4" NPT ball valve
Purchase Separately
1
1-1/2" NPT x 1-1/2" slip female adapter
2
1-1/2" Schedule 40 PVC pipe, cut to fit
3
1-1/2" NPT x 1-1/2" slip male adapter
4
1-1/4" NPT galvanized nipple, sized to fit
5
1-1/4" NPT galvanized uniot
6
1-1/4" NPT x 1-1/4" male adapter
7
1-1/4" Schedule 40 PVC pipe, cut to fit
8
1-1/4" socket to socket 90° elbow
9
1-1/4" Schedule 40 PVC pipe to drain
PVC pipe cement
PTFE pipe thread sealant tape
1-1/2" PVC solvent union - optional
Risk of fire or explosion . Do not use in
explosive atmospheres. Pump fresh water only with
this pump. Use with salt water or brine will void
the warranty.
Risk of electric shock . Plug pump into a
properly grounded, GFCI protected outlet. Do NOT plug
in the pump until after it is completely installed. Do not
remove or modify the grounding pins on the plugs.
Hazardous voltage . Can shock, burn or cause
death. Unplug pump before working on it.
4
5
6
7
Qty.
1
1
1
Qty.
1
1
1
1
1
1
1
1
as needed
2
9
B
C
6
7
8
Publicidad
Tabla de contenido
