Safety Thermostat - Manual Resetting; Proper Disposal Of The Product - Bezzera B2013 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 65
These advices are indicative, the maintenance and
cleaning schedules depend on the use of the ma-
chine.
After each use
1) Clean the steam nozzle.
2) Clean the filter holder and the filters.
Daily
1) Clean the cup holding grid and the drain ba-
sin.
2) Clean the body.
3) Clean the group's gasket with the brush sup-
plied (Fig. 07).
4) Wash the group as follows: hook the filter hold-
er with the blind filter supplied to the group (Fig.
09; pos 12) and initiate output for a few times.
5) Immerse the filter holder and the filters in hot
water for a few minutes to dissolve the grease of
the coffee, use a cloth or sponge to remove it.
For washing and cleaning operations,
do not use solvents, detergents or abra-
sive sponges but only specific products
for coffee machines. Wash the body us-
ing a cloth soaked in water and/or neutral deter-
gents, and dry the surfaces well prior to connect
the machine to the electric line again. Use water to
wash the cup holding grid and the drain basin.
6.3 Safety thermostat – Manual resetting
Warning! The operation de-
scribed below must be absolute-
ly performed by a technician au-
thorized by the manufacturer.
When the machine is on, if the boiler's resistor over
heats, the safety thermostat will be enabled, which
will interrupt the power supply, thus preventing
greater damages to the machine. To restore regu-
lar functioning, the failure that caused the enabling
of the safety thermostat must be solved and the
normal status must be reset by pressing the red key
(RESET) (Fig. 08; pos D).

6.4 Proper disposal of the product

(electric and electronic waste)
(Applicable in the countries of the European Un-
ion and in those with separated waste collection
system)
The label affixed on the product and on
the documents indicates that the prod-
BEZZERA B2013-C2013 Compact
MOD.
uct must be disposed with other domestic waste at
the end of its life cycle. To avoid possible damages
to the environment or health caused by improper
disposal of wastes, the user must separate this
product from other types of waste and recycle it
responsibly so as to favour the sustainable reuse of
material resources.
Domestic users shall contact the reseller from
whom they purchased the product or the envis-
aged local office to obtain all information relative
to the separated waste collection and recycling of
this type of product.
Corporate users shall contact their supplier to
check the terms and conditions of the purchase
agreement.
This product must not be disposed together with
other industrial waste.
37

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

C2013 compact

Tabla de contenido