Changing The Suction Motor; Using The Cleaning Hose And The Wet Cleaning Process - Dentsply Sirona inLab MC X5 Instrucciones De Uso

6 Maintenance and repair
6.2 Changing the suction motor
20
6. Remove the dusty HEPA filter and insert a new HEPA filter.
7. Put the perforated sheet back on and screw it down with the two
Phillips screws.
8. Put the filter bag back on again.
9. Put the maintenance cover on and screw it down with the two knurled
nuts.
NOTICE
Do not jam the filter bag
Make sure that the cap is sealed properly and the filter bag is not
jammed.
6.2

Changing the suction motor

The motor of the suction device has a service life of approx. 1,200 hrs.
You will notice the motor is worn when suction does not start in either
automatic or manual mode. When this happens, have the motor replaced
by a trained service engineer.
6.3
Using the cleaning hose and the wet cleaning
process
The processing chambers of devices used for dry milling of zirconium
oxide should be cleaned regularly in order to prevent deposits of
zirconium oxide dust in the chamber. A second cleaning hose with a
nozzle can be used before the wet cleaning process in order to support
the user when sucking zirconium oxide dust out of the device's
processing chamber. This hose is available separately as a spare part
(REF 65 89 795). We recommend carrying out this cleaning procedure (or
the wet milling of a restoration) at least once per week if the device is used
for dry milling of zirconium oxide.
Proceed as follows to use the cleaning hose and to execute the
recommended wet cleaning process:
1. Remove the normal hose which is connected to the milling/grinding
unit.
Operating Instructions Suction devices for inLab MC X5 and
Dentsply Sirona
64 98 609 D3608
D3608.201.02.04.02 09.2017