Carbon Brushes; Accessories - skilsaw SPT70WT Instrucciones De Funcionamiento Y Seguridad

2610039875 12-15 E_SPT70WT 12/23/15 10:55 PM Page 38
WORM DRIVE GEAR LUBRICATION
Your Skilsaw tool has been properly lubricated and
is ready to use. However it is recommended that
the gears be re-lubricated only with Skilsaw lubri-
cant: No. 80111 (8 oz. tube).
Always check the oil level before using the saw.
At a minimum, the oil should be changed once a
year under heavy use, or after approximately 60
hours of use.
To check and add oil: Remove plug from power
source. Move the blade to its lowest position.
Place the saw on a flat, stable surface with the
table facing upward. Remove oil plug using the
1/2" wrench. Check to ensure that the oil is not
below the level of the threads.
To replace the oil: Place an oil catchment under
the spigot and gently tip the table saw up so that
the oil spigot is pointing down into the oil catch-
ment and the handle is facing upwards. Allow the
oil to drain out of the gear housing. Place the table
saw back level on its feet. Using an oil refill pipette,
refill oil until it reaches the bottom threads of the
housing. Do not over fill. Replace oil plug when fin-
ished. Clean off any oil on the exterior surfaces of
the tool prior to use.
NOTE: When checking the oil, if it is dirty or thick,
replace the oil plug and run the saw for one minute
to warm up the oil. Then remove oil plug and turn
saw upside down, to remove all oil. Add fresh Skil-
saw lubricant (No. 80111). With a new saw,
change the oil after the first ten hours of use.

CARBON BRUSHES

The brushes and commutator in your tool have
been engineered for many hours of dependable
service. To maintain peak efficiency of the motor,
it is recommended to examine the brushes every
two to six months. The brushes should be free
from dust and dirt. Brushes should be replaced
when they have worn down to 3/16" in length. The
brushes should slide freely in and out of the hold-
ers without sticking.
Item
Zero Clearance Insert
Dado Insert
Table Saw Stand
To check brushes:
1. Disconnect plug from power source.
2. Move the blade to its lowest position.
3. To check top brush: Place the saw on a flat, sta-
4. Loosen the brush cap on the motor housing by
5. Clean the brush holder opening with com-
6. Replace the brush and cap.
cially designed for your tool.
Recommended Accessories
Catalog No.
SPTA70WT-ZC that accompany accessories. Use of improper
accessories may cause hazards.
SPTA70WT-DD
SPTA70WT-ST
-38-
Top Brush
Bottom Brush
ble surface with the table facing upward.
To check bottom brush: Place the saw on a flat,
stable surface with the Cord Wrap end facing
upwards.
rotating a ¼ turn using a either a short screw-
driver or a quarter, then finish removing the
brush by hand.
Note which way the brush faces, so that it can
be returned to its original position.
pressed air or a clean cloth.
Use only genuine Skil replace-
ment brushes (No. 95111) spe-
WARNING
Use only recommended ac-
cessories. Follow instructions
WARNING
Oil Plug
FIG. 66