CAMPAGNOLO NEUTRON ULTRA PART 2 Manual De Uso página 40

6.4 – REMOVAL AND INSTALLATION OF PAWLS
Remove the spring by slightly raising the pawl (A - Fig. 33), being careful not to
distort it. Pull out the pawls and replace them if necessary. Insert the bent part of
the spring into the hole of the pawl carrier. Fit the spring between the openings in
each pawl, simultaneously setting the pawls into their final position (Fig. 34A). When
the operation is complete make sure that all three pawls rotate freely and remain
in the open position (Fig. 34B).
6.5 - FITTING THE FREEWHEEL BODY ON THE HUB
Place the freewheel on the hub and hold it in position, lower the three pawls one
by one with the Allen wrench or with a screwdriver and fully insert the freewheel
in its seat (Fig. 35). Tighten the locking screw with the 17 mm wrench (Fig. 36), hol-
ding the axle steady on the freewheel side with a fully inserted 5 mm Allen wrench
(tightening torque: 15 N.m - 11 lb.ft).
34
A B
35
33
A
36
CLOSE
15 N.m - 11 lb.ft
19