Vimar RS02 Manual De Instrucciones Para La Conexión Y El Uso página 33

RS02
The gate/barrier closes
as far as the mechanical
stop
The gate/barrier
performs
full opening
Starting with the gate/barrier not fully closed, after entering programming mode by pressing the UP, OK, and AP/CH button once, the gate/barrier starts
closing to find the mechanical stop for closing. It automatically starts opening at low speed until it reaches the mechanical stop for opening. After 2 sec-
onds the gate/barrier starts closing at cycle speed and slows down approximately 50 cm from complete closing and continues until completely closed. The
control panel saves the gate/barrier travel and automatically performs a complete opening and closing cycle to save the current thresholds with default
deceleration speed and distances. The word END on the display indicates the end of calibration.
7.2 Procedure for saving a remote control associated with button APCH:
1
Press the UP button 2 times, the display will show RAD
Press the OK button, the display will show 1CH (indicating that the remote control button will be saved as AP/CH of the control panel) Press the OK button,
4 dots will appear on the display, indicating that the control panel is waiting for a remote control button to be tapped (timeout 10 seconds) After pressing
the remote control button the display will show a 4-digit number: the first digit indicates association (1 controls the AP/CH input 2 controls the pedestrian
entrance or the second channel output) the other 3 indicate the memory cell occupied by the remote control (the first remote control occupies cell 001,
the second one cell 002), the maximum capacity is 200 remote controls To save other remote controls repeat the procedure.
N.B.: The first saved remote control configures the control panel to accept only remote controls with a rolling code or only remote controls with a fixed
12-bit code
1
The gate/barrier goes into
the fully open position and
slow speed
The gate/barrier
performs
full closing
2
x2
2
The gate/barrier closes
at cycle speed
3
5
EN
3
Continues closing at
reduced speed until
completely closed
4
31