Novoferm NovoDock L150 Instrucciones De Montaje página 8

5. Installing the fixed drawbridge leveller, type W
5.2
EN
5.3 Installation
• First of all, check that the position where the drawbridge leveller is to be installed offers adequate free space for operation when in use.
• Packing is required if there is a gap of more than 1 mm between the hinge plate (1) and the steel U profile (2).
• The top joint along the entire length of the hinge plate should be prepared for a continuous weld.
• Before welding, the zinc coating should be removed in the area of the welded joint.
• The bottom welded joint should be welded alternately starting from the left and from the right (see figure).
• A central weld where L=500 mm is required in the area of the hinge plate.
• The side weld should be executed in accordance with the figure.
• After welding, the attachment fittings should be removed and the welded seams protected against corrosion.
Painting welded and damaged surfaces:
5.4
• Surfaces that are to be painted must be dry and free of dirt, grease, rust, etc.
• Spray cold galvanising paint on the surfaces and allow to dry for approximately 30 minutes
• After installation, apply a final coat of paint to all areas of paint damage using the touch-up paint provided.
5.5 Marshalling space
Adequate marshalling space must be provided for parking up materials handling equipment, if required
6
This installation manual must be given to the customer and kept safely during the entire period of use!
Instruction
1. Hinge plate
2. Steel U profile
All dimensions in mm
General instruction: The image may differ at detail level.