Automatic Mode - John Bean B 1200P Manual De Operador

0
60
5-15
5-16
5-17
5-18
Operation "BALANCE WITH RUN OUT"
5.4

AUTOMATIC mode

"BALANCE WITH RUN OUT"
The following instructions describe the specific
functions of the balancer in the "BALANCE WITH RUN
OUT" mode.
Icon (0) shown in Figure 5-15 identifies active
"BALANCE WITH RUN OUT" mode. The unit runs
automatically.
This mode allows operator to measure wheel run-out
or wheel + rim run-out by means of one or two laser
scanners (Fig. 5-16).
The two different measurements can be set through
the setting panel (Fig. 5-17).
If user sets "Rim run-out measurement" to "Limit
exceeded" (Fig 5-17), machine will only run wheel
measurement - and rim will be measured, too, only
if the value set for "Wheel radial run-out limit (1
Harmonic)" is exceeded.
If user sets "Rim run-out measurement" to "Always"
(Fig 5-18) machine will measure both wheel and rim.
st