Pacojet Junior Manual De Instrucciones página 33

EN
Cleaning cycle
1
2
1.
2.
3.
4.
28
Insert the empty pacotizing beaker (10) into the
protective beaker (12).
Place the blue cleaning insert (15) into the pacotizing
beaker (10) with the brushes pointing upwards.
Then place the blue sealing ring (14) onto the
pacotizing beaker.
Fill the pacotizing beaker (10) with warm water
(approx. 58 °C) until it reaches the bottom edge of
the brushes.
Add the specified quantity of cleaning agent
(see Chapter "8.1.2 Cleaning agents" on page 24).
Attach the protective beaker (12) with the pacotizing
beaker (10) to the Pacojet Junior.
To do this, slide the upright protective beaker with
pacotizing beaker upwards into the rounded mold on
the base to center it
1
Start this step by making sure that the handle is
pointing to the right in the starting position and that
the top of the pacotizing beaker is flat on the device.
Turn the protective beaker from right to left
approximately 90° to the left until the stop in the
holder .
2
The handle will point forwards when the protective
beaker is attached correctly.
Note
Risk of damage caused by using the wrong
accessories!
• Never use the pacotizing blade (9) for the
cleaning cycle.
.