Ec Declaration Of Conformity - Dolmar MS-4211 Manual De Instrucciones

Never straighten or weld damaged cutting tools.
– Operate the brush cutter with as little noise and contamination as possible.
In particular, check the correct setting of the carburetor.
– Clean the brush cutter at regular intervals and check that all screws and nuts
are well tightened.
– Never service or store the brush cutter in the vicinity of open flames.
– Always store the brush cutter in locked rooms and with an emptied fuel tank.
Observe the relevant accident prevention instructions issued by the relevant
trade associations and by the insurance companies.
Do not perform any modifications on the brush cutter as this will endanger your
safety.
The performance of maintenance or repair work by the user is limited to those
activities as described in the instruction manual. All the other work is to be done
by an Authorized Service Agent. Use only genuine spare parts and accessories
released and supplied by DOLMAR.
Use of non-approved accessories and tools means increased risk of accidents.
DOLMAR will not accept any liability for accidents or damage caused by the use of
non-approved cutting tools and fixing devices of cutting tools, or accessories.
First Aid
In case of accident, make sure that a first-aid box is available in the vicinity of
the cutting operations. Immediately replace any item taken from the first aid
box.
When asking for help, please give the following information:
– Place of accident
– What happened
– Number of injured persons
– Kind of injuries
– Your name
Packaging
The DOLMAR brush cutter will be delivered in two protective cardboard boxes
to prevent transport damage. Cardboard is a basic raw material and is
therefore consequently reusable or suitable for recycling (waste paper
recycling).
Brush Cutter: model MS-4211 (See TECHNICAL DATA for the specifications)
We declare under our sole responsibility that this product is in compliance with the following Directives, 2000/14/EC, 2006/42/EC.
The most important standards applied to properly meet the requirements of the above Directives were: EN11806.
Measured Sound Power: 114 dB
Guarantee Sound Power: 118 dB
These sound power levels were measured in accordance with Council Directive, 2000/14/EC.
Conformity assessment procedure: Annex V.
Responsible Manufacturer:
Makita Corporation.
3-11-8, Sumiyoshi-cho, Anjo, Aichi, JAPAN
Authorized Representative in Europe:
DOLMAR Gmbh
Jenfelder Str. 38, 22045 Hamburg, Germany
EC-DECLARATION OF CONFORMITY
3rd. NOV. 2009
Tamiro Kishima
Managing Director
6
Rainer Bergfeld
Managing Director