Specifications; Accessory; Applications; Prior To Operation - Hitachi Koki EC 129 Manual De Instrucciones

English

SPECIFICATIONS

Model
Motor
Power Source
Output Power
Current
Tank Capacity
Maximum Pressure
at 40 PSI
(2.8 bar)
Free Air
at 90 PSI
Delivery
(6.2 bar)
at 100 PSI
(6.9 bar)
Lubrication

ACCESSORY

WARNING:
Accessory other than these shown
below can lead to malfunction and
resulting injuries.
STANDARD ACCESSORY

APPLICATIONS

Air source of the pneumatic nailer and stapler.
WARNING:
Never use compressor for
applications other than compressor
for pneumatic nailer and stapler.

PRIOR TO OPERATION

1. Power source
Ensure that the power source to be utilized conforms
to the power source requirements specified on the
product nameplate.
Dipstick ............................... 1
— 10 —
EC129
Single-Phase, Induction Motor
Single-Phase, 120V AC 60Hz
2.5 HP
(1.8 KW)
15.0 A
5 gal.
(18.9 ltr)
125 PSI
(8.6 bar)
6.0 CFM
(170 ltr/min)
4.7 CFM
(133 ltr/min)
4.4 CFM
(125 ltr/min)
Oil
2. Power switch
Ensure that the knob of the pressure switch is in the
"OFF" position (Fig. 2). If the plug is connected to a
receptacle while the knob is in the "ON" position, the
compressor will start operating immediately and can
cause serious injury.
3. Extension cord
When the work area is far away from the power
source, use an extension cord of sufficient thickness
and rated capacity (refer page 7). The extension cord
should be kept as short as practicable.
WARNING:
Damaged cord must be replaced or
repaired.
4. Confirm the power receptacle
If the power receptacle only loosely accepts the plug,
the receptacle must be repaired. Contact the nearest
electric store for repair service.
If such a faulty receptacle is used, may cause
overheating, resulting in a serious hazard.
Knob of the pressure switch
Fig. 2