Publicidad
Idiomas disponibles
Idiomas disponibles
3.
Position the steering wheel assembly over the lower steering shaft on the
tractor. Align the steering wheel so that its largest opening faces forward
when the tractor wheels are straight.
4.
Lower the steering wheel assembly (a) onto the lower steering shaft (b) and
secure with the shoulder bolt (c) and lock nut (d)previously removed. See
Figure 2.
5.
Tighten the shoulder bolt and lock nut using a 9/16" wrench or socket and
7/16"wrench or socket.
6.
Remove the pedestal cap mount screw factory installed and located on the
tractor's steering console. Retain the screw for later instructions. See Figure 3.
(c)
2
(b)
(b)
7.
Connect the headlight wire terminals (a). Slide the pedestal cap (b) down
onto the tractor and slightly rotate to the right to clip into place. Secure the
pedestal cap (b) with the screw (c) previously removed. See Figure 3.
Attaching the Seat
If the seat for your tractor was not attached at the factory, follow the applicable
instructions below to attach it.
1.
Remove the shoulder bolts (a) and lock nuts (b) from the seat mounting
bracket (c) included in your hardware pack. See Figure 4.
(b)
(a)
(a)
1
Figure 3
(a)
(b)
(c)
Figure 4
ASSEMBLY
2.
Remove the two self-tapping bolts (a) factory installed on the tractor. See
Figure 5.
3.
Align the seat bracket (a) in place over the holes from where the self-tapping
bolts (b) were removed, as shown in Figure 6.
4.
Using a 1/4" drive ratchet with a 3/8" socket, secure the seat bracket (a) with
the self-tapping bolts (b) removed in step 2. See Figure 6.
Do not use any type of power tool (e.g. impact gun or electric drill with nut
driver attached) when tightening the self-tapping bolts to attach the seat
bracket.
10
(a)
(a)
Figure 5
(b)
(a)
(b)
Figure 6
CAUTION
Publicidad
