Medisana MTD Instrucciones De Manejo página 25

3.2 Alternatively, the unit may also be operated with a special power adapter
Using a mains (MEDISANA item no. 51125), which is plugged into the connector
adaptor on the right-hand side of the unit. In this case the batteries remain in the unit.
The batteries are disconnected mechanically when the connector is inserted on
the right-hand side of the blood pressure monitor. It is necessary, therefore, to
plug the mains adaptor into the mains socket first of all and then to connect it
to the blood pressure monitor. If the blood pressure monitor is no longer being
used, first remove the connector from the blood pressure monitor and then pull
the mains adaptor out of the mains socket. Doing this means that the date and
time will not have to be reset each time.
a. Initial setting:
3.3
Setting the
As soon as you have inserted the batteries, the device automatically switched to
reception for the
the radio clock mode. While searching for the time signal, the radio clock signal
time signal (RCC)
flashes. As soon as the clock receives an adequate signal for setting, the time and
(RCC = Radio
date are set automatically. When the setting process is finished, the device
Controlled Clock)
switches to stand-by mode, in which time and date are displayed permanently.
If no signal is received, the device goes directly to stand-by mode without
changing the preset time and date.
By pressing the Start button
can be switched off. The device goes directly to stand-by mode without changing
the preset time and date.
b. Quick radio clock setting
When the device is in stand-by mode and you press the START button
MEM button
setting mode for the radio clock. The radio clock symbol flashes. When the time
signal is received, the time and date are set automatically. If no signal is received,
the device switches to the manual time setting mode.
The quick setting can be cancelled by pressing the START button
then switched to the manual time settimg mode.
c. regular signal reception
The device automatically receives the radio signal to update the time setting
twice a day, at 2.05 a.m. and 2.05 p.m.
By pressing the START button
be switched off.
the initial setting reception of the time signal
simultaneously for approx. 1 second, you will go to the quick
the regular reception of the time signal can
3 Getting Started
. The device
GB
provided
and
19