Setting The Date And Time; On/Off Switch - Medisana MTD Instrucciones De Manejo

GB
3 Getting Started
3.4
Setting the date
and time
3.5
Adjusting the
voice function
3.6
Holder
3.7

ON/OFF switch

I/0
20
The time and date are normally set automatically by radio along with the time
signal. When no time signal is received, or it is too weak, the clock can also be
set manually.
1. The device is in stand-by mode. Press the START button
simultaneously to go to the quick setting mode for the radio clock. Now
press the START button
2. The digit for entering the month flashes first. By pressing the START button
repeatedly, the digits for the day, hour and minute will flash in succession.
While each input position is flashing, press the MEM button
corresponding digit. By holding the MEM button
be speeded up.
3. Exit the time setting mode by pressing the START button
position is flashing. It will switch to stand-by mode.
After changing the batteries the clock will need to be reset, either automatically
by radio signal or manually by time setting mode.
The voice function can be adjusted with the device switched on ( ON/OFF
switch in I position ), i.e. with just the date and time displayed. Press and
hold down the MEM button
play (e.g. L1).
L0 = Language function switched off
L1 = German
L2 = English
L3 = Spanish
The device speaks the language setting, and changes the display and the an-
nouncement to the next language if the MEM button
selected language can be changed by releasing the MEM button
as the language that you require is displayed or spoken. The selected volume,
which is indicated by flashing bars, can be modified by pressing the MEM
button again and holding it down until the required volume is indicated –
the higher the bar, the louder the volume. Release the MEM button
confirm your selection. The bar stops flashing and the display switches back to
the time display.
Using the holder included with the unit you will store the arm cuff and the air
hose together with the device. First attach the adhesive pad to the rear side of
the unit, then fix the holder on it firmly.
Your device has a touch screen as an equipment. Be careful not to touch the
display by mistake. Keep the ON/OFF switch
is not in use to avoid unintentional adjustments.
to go to the manual time setting mode.
until the selected language appears on the dis-
L4 = Dutch
L5 = French
L6 = Italian
L7 = Portuguese
in 0 position when the device
and MEM button
to enter the
the setting process can
while the minute
is held down. The
as soon
to