Changing The Battery Pack; Capacity Display; Festool Charger - Festool HKC 55 EB Manual De Instrucciones

HKC 55 EB
GB
[1-3] Lever for changing blades
[1-4] Retractor lever for pendulum guard
[1-5] Guide wedge
[1-6] Pendulum guard
[1-7] On/Off switch
[1-8] Lever for plunge function
[1-9] Split scale for cutting depth stop (with/
without guide rail)
[1-10] Extractor connector
[1-11] Angle scale
[1-12] Knob for angle setting
[1-13] Cutting depth adjuster
[1-14] Battery pack
[1-15] Adjustable jaws

[1-16] Capacity display

[1-17] Insulated gripping surfaces (grey shaded
area)
[4] Wall mount for charger
6 Operation
6.1

Changing the battery pack

The battery pack is delivered partially charged.
Charge the battery pack completely before us-
ing for the first time.
Removing the battery pack [2 A]
Inserting the battery pack [2 B]
6.2 Capacity display
The capacity display [1-16] automatically displays
the charge state of the battery pack [1-7] when the
ON/OFF switch is actuated:
70 - 100 %
40 - 70 %
15 - 40 %
< 15 %
Recommendation: Charge bat-
tery pack before further use.
6.3

Festool charger

Charging the battery pack [3]
The LED [3-1] on the charger indicates the respec-
tive operating status of the charger.
LED yellow - lit continuously
Charger is ready to use.
20
LED green - flashing quickly
Charging battery pack at maxi-
mum rate.
LED green - flashing slowly
Charging battery pack with
reduced current, begins at 90%
battery level.
LED green - lit continuously
Charging process is complete or
will not resume because the cur-
rent battery level is above 90%.
LED red - flashing
General fault indication, e.g.
incomplete contact, short circuit,
defective battery pack, etc.
LED red - lit continuously
Battery temperature is outside
the permitted range.
Charger cable holder [3-2]
Unwind the cable completely from the recess
before using the charger.
7 Settings
WARNING
Risk of injury
Always disconnect the battery pack before per-
forming any type of work on the machine!
7.1 Electronics
Smooth start-up
The electronically controlled smooth start-up en-
sures that the machine starts up jolt-free.
Constant speed
The motor speed remains constant through elec-
tronic control to ensure a uniform cutting speed
even when under load.
Current limiting
Current limiting prevents excessive current con-
sumption under extreme overload, which can lead
to a decrease in the motor speed. The motor imme-
diately restarts after the load is removed.
Brake
The HKC 55 EB is fitted with an electronic brake.
When the saw is switched off, the saw blade slows
to a stop electronically within approx. 2 seconds.