Festool HKC 55 EB Manual De Instrucciones página 24

HKC 55 EB
GB
Every time before use, check that the cross
cutting guide rail is retracted correctly and
have it repaired, if necessary. Never use if
automatic retraction is not operating cor-
rectly.
Connect saw to the cross cutting guide rail
Slide saw onto the cross cutting guide rail in
sawing direction.
The saw engages in the sliding block [11-2] .
The quick fastener [11-1] locks in behind the
saw table.
The saw is securely connected to the cross cutting
guide rail.
Loosen saw from the cross cutting guide rail.
Push saw forward slightly in sawing direction.
Turn quick fastener [11-1] to the front.
Remove saw towards the rear against the saw-
ing direction.
Cutting with the compound mitre saw
Open knob at adjustable stop [12-2].
Adjust angle at the scale [12-4].
Close knob at adjustable stop [12-2].
Adjust depth and angle of the saw, see ch. 7.2
and 7.3.
The saw's play on the cross cutting guide rails
can be set with the two setting jaws [12-3].
The saw must slide easily across the rail.
Place the adjustable stop [12-2] and the fixed
stop against the work piece and position the
cross cutting guide rail.
Switch saw on.
Push saw in direction of cutting.
Pendulum guard opens. Sawing commences.
WARNING
Protruding rotating saw blade
Risk of injury
Do not position hands near cutting area and saw
blade.
Do not place hands below the work piece.
Do not hold the workpiece in hand or place it on
your leg.
After cutting, switch off saw.
Pull back saw into initial position.
Remove cross cutting guide rail from work
piece.
24
not lay down! If the saw or the pendulum guard
does not retreat to initial position, interrupt sawing
process and check functionality, possibly remove
jammed woodchips.
laid down with the cross cutting guide rail.
11 Environment
Do not dispose of the device in house-
hold waste! Recycle devices, accesso-
ries and packaging. Observe applica-
ble national regulations.
EU only: In accordance with European
Directive on waste electrical and electronic equip-
ment and implementation in national law, used
electric power tools must be collected separately
and handed in for environmentally friendly recy-
cling.
Return used or faulty battery packs to your local
specialist retailer, Festool after-sales service or
nearest public waste management facility (observe
applicable regulations). Batteries must be dis-
charged on return. Battery packs will then be recy-
cled.
EU only: In accordance with the European Directive
on batteries and implementation in national law,
defective or used battery packs/batteries must be
collected separately and handed in for environmen-
tally friendly recycling.
Information on REACh: www.festool.com/reach
12 Transport
The lithium-ion batteries are subject to the require-
ments of the legislation on hazardous goods. A li-
ion battery pack alone falls below the applicable
limit value and certified as per UN manual ST/SG/
AC.10/11/rev. 3 part III, subsection 38.3. However,
dangerous goods regulations may apply when sev-
eral battery packs are transported For shipping by
third parties (e.g. air transport or freight forward-
ing company) special requirements with regard to
packaging and labelling must be observed. For the
preparation of the package an expert on hazardous
goods must be consulted. Please observe any fur-
ther national regulations.
Only return the battery pack if the housing is un-
damaged. Tape over the exposed contacts and wrap
the battery pack so that it cannot move inside the
packaging.
Warning! Danger
of injury!
blade exposed, do
Parking position - pendu-
lum guard closed! In park-
ing position the saw can be
Saw