Checkweighing/Checkcounting - Mettler Toledo ICS241 Instrucciones De Manejo

30232251A ICS241

3.4 Checkweighing/checkcounting

The device offers checkweighing/checkcounting functions. The respective settings in the
menu are described in the Application menu section, see section 4.3, page 32.
Prerequisite
9 The soft keys for checkweighing/checkcounting are activated in the Terminal menu.
3.4.1 Checkweighing/checkcounting tolerance types
Different entries are required at the beginning of checkweighing or checkcounting,
depending on the tolerance type setting.
Tolerance type "Absolute"
A low and a high weight value must be entered. These weights and all weights within this
range are treated as being within tolerance.
Tolerance type "Relative"
Target weight (Target) as well as lower tolerance (Tol –) and upper tolerance (Tol +) have
to be specified. The tolerances are displayed as relative deviations from the target weight.
Tolerance type "Percent"
Target weight (Target) as well as lower tolerance (Tol –) and upper tolerance (Tol +)
have to be specified in percent. At checkweighing the weight value is represented as a
percentage of the target weight. Either target weight 100 % is striven for, or 0 % in the
over/under checkweighing to zero mode.
3.4.2 Specifying target values
The following section describes the procedure with regard to the factory setting of the
checkweighing/checkcounting application.
1. Press .
The current checkweighing parameters are displayed.
2. Use to change the tolerance type and
If a tolerance type is selected in the menu, this step is skipped.
3. Enter the requested weight and press
The next parameter is highlighted.
4. Repeat step 3 until New target set! is displayed.
The checkweighing screen is displayed, the scale is ready for checkweighing.
to proceed to the first low target.
.
21
Application