Mettler Toledo ICS241 Instrucciones De Manejo página 34

Tolerance type
Off
Absolute
Relative
Percent
Default values
Activate
Relative weight
Percent weight
Relative pieces
Output
Good print
Article name
Article number
Activate
Delete all
Delete record
Print records
Note
34
Menu settings
Application –> Over/Under – Set checkweighing parameters
Specify which parameters have to be entered for checkweighing.
No tolerance type predefined. It can be set individually when entering checkweighing/
checkcounting parameters.
A low and a high tolerance value must be entered. These weights and all weights within
this range are treated as being within tolerance.
The target weight has to be entered as an absolute weight, upper and lower tolerances
as weight deviations from the target weight.
The target weight has to be entered as an absolute weight, upper and lower tolerances
as deviations in percent from the target weight. Not possible for counting.
If you always use the same tolerances for checkweighing/checkcounting, you can store
these tolerances and thus avoid entering tolerances all the time.
Activating usage of default tolerance values:
• Off: Default tolerance values not used
• On: Default tolerance values used
Relative weight: Enter the weight values for Tolerance – and Tolerance +.
Percent weight: Enter the percentages for Tolerance – and Tolerance +.
Relative pieces: Enter Tolerance – and Tolerance + in pieces.
Set display and printing options.
Automatic printout.
• Off: No automatic printout.
• On: Automatic printout when a stable weight value within the tolerance values exists.
Application –> Data storage – Set data storage parameters
Article name and article number can be assigned to each record.
They are saved as part of a targeted record, which can be displayed, printed or sent.
The maximum length of each article name and article number is 40 characters.
Activate article name or article number to identify checkweighing/checkcounting
parameter settings.
• Deactivate: Article name and article number cannot be defined during the target
definition.
• Activate: When you press the target key, you can enter article name or article
number via keyboard.
Delete all records. Before the records are deleted, a warning message is displayed.
Delete one record.
Print all records.
The data record can be edited via SICS command.
ICS241 30232251A