Calibration Programmes - Corghi ProLine 640 Manual De Uso

pressing the key:
the weights necessary for balancing the
wheel are displayed. The execution of
the programme is interrupted, thus not
achieving the moderate improvement of
the end results. By pressing the
key the optimisation procedure can be
continued.
- At the end of the first spin the instruction
that the tyre is to be mounted on the rim
in the reverse direction may appear. If
you do not intend to reverse the tyre or if
doing so is impossible, press the
key and the machine will provide the in-
structions for completing the programme
without reversing the tyre.
CALIBRATION
PROGRAMMES
Sensitivity Calibration
Calibrate when detecting that the setting
condition is out-of-tolerance or when the
machine so requires as the "E1" message
is displayed.
- Fit a wheel of average dimensions (pref-
erably with only small unbalance) on the
wheel balancer.
- Set the wheel geometric data correctly.
- Press the
luminous dot corresponding to the CAL
programme
- Press the key
tion.
- After the selection, the machine will display
the message:
User manual ProLine 640
the values of
keys until the
illuminates.
to confirm the selec-
• CAL on the left-hand display;
• GO on the right-hand display.
- Perform a first spin.
- At the end of the spin, turn the wheel un-
til it reaches the position marked by the
position indicator and the message "100"
("3.5" if the ounces view mode has been
selected) is displayed.
- Apply a sample weight of 100 grammes
(3.5 oz) on the INNER side of the rim, at
exactly 12 o'clock.
- Perform a second spin.
- At the end of the spin, remove the sample
weight and turn the wheel until it reaches
the position marked by the position indi-
cator and the message "100" (or "3.5") is
displayed.
- Apply the sample weight of 100 grams (3.5
oz) to the OUTSIDE of the rim, at exactly
12 o'clock.
- Perform a third spin.
This last calibration phase includes the
execution of three consecutive spins in
automatic mode.
At the end of the spin(the message "End
CAL" will appear on the display), if the
calibration has been successful, an acoustic
consent signal goes off at the end of the spin
otherwise the message E 2 is temporarily
displayed.
NOTES
- On completion of the procedure, remove
the sample weight of 100 gr (3.5 oz).
- Pressing the key
interrupt the programme at any time.
- THE CALIBRATION PERFORMED IS VALID
FOR ANY TYPE OF WHEEL!
UK
, it is possible to
61