Checking The Rear Brake Pads For Wear - SHERCO 50 SE Manual De Propietario

The brake fluid is highly corrosive, do not allow any to drip on the painted parts
of the vehicle.
For this operation, use protective gloves.
Keep the brake fluid out of the reach of children.
In case of contact:
- with eyes, rinse immediately with water and seek medical attention.
- with the skin, immediately wash the affected parts with soap and water.
Change clothes immediately If they become contaminated by the brake fluid.
If swallowed, seek medical attention immediately
CHECKING THE REAR BRAKE
PADS FOR WEAR
The state of wear of the brake pads can be
checked by observing the end of the 2 pads
on the caliper (see arrow) they should have a
minimum thickness of 2 mm.
In the case of a lower thickness, immediately
replace them.
Note:
Perform this check according to the schedule
shown on the chart at
For replacement, contact a SHERCO
authorized service center.
p.90.
☛
81