Selection Of Audio/Video; Source - Aiwa AV-DV70 Manual De Instrucciones

SELECTION OF AUDIO/VIDEO
SOURCE
1
1
DOWNY, UPA
Select the program source.
Press one of the function buttons or the TAPE MONITOR
button.
Radio TUNER
Record PHONO
Television, etc. AUX
I Compact disc I CD
I
Video VIDEO 1, VIDEO 2, VIDEO 3
LD or Cable TV VIDEO 2
MD or DVD VIDEO 1
The function buttons to be pressed (except PHONO) depend
on the equipment connected to the input terminals on the
rear panel of the unit.
ma
When using a turntable with a built-in equalizer amplifier, set the
switch of the equalizer amplifier to off. See the instructions of
the turntable for further information.
2 Start the selected program
source.
3 Adjust the sound.
To change a displayed name for the VIDEO 1 button
and
VIDEO 2 button
When the VIDEO 1 button is pressed, VIDEO 1 is displayed
initially. It can be changed to DVD or MD.
With the power on, press the POWER button while pressing the
VIDEO 1 button.
The displayed name for the VIDEO 2 button can be changeld to
VIDEO 2, LD or TV; with the power on, press the POWER buitton
while pressing the VIDEO 2 button.
To select the
"ANALOG" or "DIGITAL" (Dolby Digital
Surround) mode of the VIDEO 1 or VIDEO 2 function
The VIDEO 1 or VIDEO 2 button also works as the DIGITAU
ANALOG selector.
Press the VIDEO '1 (VIDEO 2) button and hold it down.
"ANALOG" or "DIGI1-AL" appears on the display one after the
other. Release the button when the desired mode is displayed.
In the DIGITAL
modle: Equipment connected to the OPTICAL
DIGITAL IN terminal is selected as a source for the VIDEO 1
button, and one connected to the COAXIAL DIGITAL IN terminal
for the VIDEO 2 button.
In the ANALOG mode:
Equipment connected to the VIDEO 1/
DVD/MD IN terminals is selected as a source for the VIDEO 1
button, and one connected to the VIDEO 2/LD/TV terminals for
the VIDEO 2 button.
m
The "DIGITAL" mode changes to the "ANALOG, " when pressing
the TAPE MONITOR button.
When the "OVER L. E VEL" indicator lights up
The unit is equipped with the OVER LEVEL indicator. When input
analog signals from the connected equipment are too high to
accept, the indicator lights on the left side of the display. In this
case, adjust the input level as mentioned below so that the
indicator disappears,
To adjust the sound level of the connected source
The input sensitivity level of each function can be adjusted
(except the TUNER,
VIDEO 1 (DIGITAL) and VIDEO 2 (DIGITAL)
functions),
When the sound level of the connected source is higher or lower
than that of the TUNIER, adjust it as follows.
1
2
About the
video source to the monitor or TV
Selected VIDEO source
Vi: VIDEO 1, V2: VIDEO 2, V3: VIDEO 3
The selected video source is indicated on the display and the
video signal through the MONITOR VIDEO OUT jack is output
on the TV.
Select the function to be adjusted.
Press one of the function buttons or the TAPE MONITOR
button and play the source.
Press the UPA or DOWNY button repeatedly
Adjust the level so that the "OVER LEVEL" indicator does
not light on the display.
The level can be adjusted between -6d B (M IN) and +i8dB
(MAX) in 2dB steps. Adjust the level so that the sound is
output at the same level as the TUNER.
The input sensitivity level of the TAPE MONITOR can be
adjusted to OdB or -6dB.
* Before adjusting the level of the TAPE MONITOR, select
the function except TUNER.
ENGL/SH
10