Manual Tuning; Direct Tuning - Aiwa AV-DV70 Manual De Instrucciones

MANUAL TUNING
DIRECT TUNING
1
2
MONO
TUNER
Press the TUNER button repeatedly to select the
desired band.
~FM~AM-1
I
I
The display changes to frequency indications after indicating
band and video source (VI, V2 or V3) for two seconds.
When the TUNER button is pressed while the power is off,
the power is turned on directly.
Press the
UPA
or DOWNY button to select a
station.
Each time the button is pressed, the frequency changes.
When a station is received, "TUNE" is displayed for two
seconds. During FM stereo reception, [i@Ill is displayed.
To search for a station quickly (Auto Search)
Keep the UPA or DOWNY button pressed until the tuner starts
searching for a station. After tuning in to a station, the search
stops.
To stop the Auto Search manually, press the
UPA
or DOWNY
button.
The Auto Search may not stop at stations with very weak
signals.
When an FM stereo broadcast contains noise
Press the MONO TUNER button on the remote control so that
"MONO" appears on the display.
Noise is reduced, although reception is monaural.
MONO
To restore stereo reception, press the button so that "MONO"
disappears.
When the reception contains noise interference
Move the unit away from other electrical appliances, especially
digital audio devices, or turn off the appliances that generate
noise signals.
POWER 1,2
3
DOWNY, UPA
When you know the frequency of the desired station, you can
tune in directly to the station.
1 Press the TUNER button to select a band.
2 Press the TUNER button and hold it down until
"
"flashes
011
the display (Direct Tuning
Modle). . . . . .
3 Press the appropriate numbered buttons
to tume
in to the desired station.
Example:
To tune in to 106,50 MHz, press the 1, 0, 6, 5 and O buttcms.
To tune in to 95.20 MHz, press the 9, 5, 2 and Q buttons.
m
To cancel the Direct tuning mode
Press the UPA or DOWNV button.
When entering a frequency out of tuning range, the value
flashes for two seconds and then goes off. Check the frequency
and repeat step 3 correctly.
When entering a frequency not covered by the tuning interval,
the value is automatically rounded up or down to the closest
one covered by it.
The DIGIT buttons cm the remote control can not be l~sed when
tuning in to the desllred station.
To change the AM tuning interval
The default setting of the AM tuning interval is
10 kHz/step If
you use this unit in an area where the frequency allocation
system is 9 kHz/step, change the tuning interval.
Hold down the TUNER button and press the POWER button
immediately. Note that the unit is set to the Direct Tuning mode
if the TUNER button is pressed and held down for about haLf
a second.
To reset the interval, repeat this procedure.
ENGLISH 12