Driver Installation - Bresser BIOLUX NV 51-16200 Instrucciones De Uso

computer. The installation menu starts
automatically. If it does not, go to the
Windows explorer and select the CD/DVD
drive (most of the time, it's the "D" drive, but
it can have another letter). From there, start
the file "menu.exe" by double-clicking with
the left mouse button.
10.2.1. Driver installation
To install the driver software, click on the menu
point "Install Driver" with the mouse cursor.
Then follow the installation program instructions.
During the software installation the correct
driver for your operating system will be installed
automatically. No manual input is needed. In
rare cases the device may not be recognised
by your computer. As a rule you need then only
install the driver manually from the CD. If this
fails please refer to the troubleshooting chapter
that follows.
10.2.2. I nstallation of the Image Editing
Software Photomizer SE
The image editing software "Photomizer SE"
is located on the software CD. You can edit
your pictures here.
1. To install the software, click once on the
menu point "Install Software" with the left
mouse button.
2. The Photomizer Software
Microsoft .NET Framework 3.5, which it
will install if it is not already on your system.
22
If it is already on your system, you may skip
to step 5.
3. In the welcome window, please accept
the Microsoft license agreement, and then
click "Install". The installation can take a
few minutes.
4. As soon as everything is installed, click
"Finish".
5. Now you will be presented with a choice,
in which you can choose your language.
Make your selection and confirm it by
clicking „OK".
6. When you see "Welcome", click on
„Next".
7. In the next window, you will be asked for
the „Destination Folder". Here, just click on
„Next".
8. Now, the window with the Setup-Status will
appear – here, a progress bar will inform
you about the ongoing installation. This
process can take a few minutes.
9. The window "Photomizer is being installed"
appears. Click on "Finish". The installation
ends.
Tip:
i
To use the MikrOkular long-
term we recommend it al-
ways be connected to the
same USB port.
requires
10.3. T roubleshooting: the device isn't
recognised by the computer (USB)
1. This occurs in rare cases whith some OEM
Windows Vista or XP versions. The device
is not defective. Updating the notebook or
PC USB driver usually suffices.
2. If not, proceed as below. (The maker
cannot accept any liability whatsoever in
these cases1).
Delete ghost devices. These are devices not
actually currently connected to your computer.
The reason for this is that Windows generates
a system settings entry for each USB device
( e.g USB Stick) on each port. It then seeks
that/those device/s each time it's started.
This slows down USB device recognition and
Windows booting and causes non-recognition
of USB ports.
Cleaning up the system
and deleting devices that are no longer
in use helps here. To do so right click
WORKPLACE (COMPUTER in Vista) and
open the PROPERTIES menu. Then click
the ADVANCED tab (ADVANCED SYSTEM
SETTINGS in Vista) and then ENVIRONMENT
VARIABLES. Choose the NEW option in
ENVIRONMENT VARIABLES.
following under VARIABLE NAME.
devmgr_show_nonpresent_devices
Under VARIABLE VALUE enter „1".
Confirm your input with OK and then reboot
the computer.
environment
Enter the