If the AUTO ID function is launched in the spectrum analyser mode, the name of
the network will appear temporarily on screen (it also appears in the measurement
display). In case of working in the satellite band the orbital position appears as well.
Whenever the process detects new parameters for a channel or frequency will
create a new channel plan containing the detected information.
NOTE:
The
that the signal level is higher than the minimum threshold (see the
PREFERENCES menu) but demodulator cannot lock it maybe due to some
wrong configuration parameter.
In such case, the user must press AUTO ID
NOTE:
In the case that is desired to explore or identify DVB-C signals will be
necessary to select previously (TER. IDENTIFY option) a DVB-C standard
as digital signal identifier by means of
5.9
Channel plans
The signal automatic identification process as much as the exploration of the
frequency spectrum could yield the generation of new customised channel plans relative
to the usual work locations of the meter equipment.
In this way the characterisation of the band will be faster and easier when causing
that the equipment only analyses a shorter set of channels.
Whenever a new process of exploration is activated, the TV EXPLORER
ISDB-T/T
analyses all the present channels in the active channel plan, which acts as
B
pattern channel plan specified by means of the option CHANNEL SET from
configuration measurement menu: CONFIGURATION
If during exploration or automatic identification process the TV EXPLORER
ISDB-T/T
detects new parameters for some channel or frequency a new list will be
B
generated with the information updated and will be saved with the name of the original
channel plan followed by the extension: _0x, where x it is the number of the consecutive
channel plan (see the following Figure).
Page 34
icon in the upper corner of a digital measurement screen states
USER'S MANUAL TV EXPLORER
[25] key.
[22] PREFERENCES menu.
[17].
HD
ISDB-T/T
B
HD
HD
10/2012