Transferring Measurements Via App; Additional Information; Changing The Batteries - Beurer BF 1000 Instrucciones De Uso

Temporal context of the results
Please note that only the long-term trend is significant. Brief deviations in weight within a few days are nor-
mally caused by loss of fluids.
The interpretation of the results is based on changes in total body weight, percentage of body fat, body water
and muscle content, as well as on the length of time over which these changes occur. Rapid changes within the
scope of a few days are to be considered separately from medium-term changes (in the scope of weeks) and
long-term changes (months).
It can be said as a basic rule that short-term changes in weight are almost entirely changes in water content,
whereas medium-term and long-term changes may also relate to the fat percentage and the muscle percentage.
• If your weight drops in the short term but your body fat percentage increases or stays the same, you have only
lost water, for example following a training session, visit to the sauna or a diet aimed only at fast weight loss.
• On the other hand, if your weight increases in the medium term and your body fat percentage drops or stays
the same, you may have built up valuable muscle mass.
• If your weight and body fat percentage both fall at the same time, then your diet is working – you are losing fat mass.
• Ideally, you should support your diet with physical activity, fitness or strength training. This enables you to
increase your muscle percentage in the medium term.
• Body fat, body water and muscle percentages should not be totalled (muscle tissue also contains components
made of body water).

12. Transferring measurements via app

If the app is not open, the newly assigned measurements are saved on the scale. A maximum of 30 measure-
ments per user can be saved on the scale. The saved measurements are transferred automatically to the app
when you open the app within the Bluetooth range. It is possible to automatically transfer data when the scale is
Bluetooth
switched off if

13. Additional information

Deleting scale data
a) Delete user with all settings and saved values
• After switching on, select your user by pressing the [
and confirm with [SET].
• When 0.0 appears in the display, hold down the [SET] button for 12 seconds to delete the user.
• Use the [ , ] buttons to select "YES" and confirm the prompt using the [SET] button. If you do not want
to delete the user, confirm "NO" using the [SET] button.
All saved values and settings for this user will be deleted.
b) Delete individual saved value for a user
• Select a measured value in the user memory
the stored value displayed.
• You can also do this immediately after the measurement is taken.
• Use the [ , ] buttons to select "YES" and confirm the prompt using the [SET] button. If you do not want
to delete the value, confirm "NO" using the [SET] button.
c) Delete all stored values for a user
• Open the user memory
values.
• Use the [ , ] buttons to select "YES" and confirm the prompt using the [SET] button. If you do not want
to delete, confirm "NO" using the [SET] button.

Changing the batteries

The control unit has a low battery indicator. "LOW BATTERY" appears in the display if the batteries in the scale are too
weak. In this case, the batteries should be replaced. Connect the scale to the app again. The system time is updated.
NOTE:
– When replacing the batteries, use batteries of the same type, make and capacity.
– Do not use rechargeable batteries.
– Use batteries free from heavy metals.
® is enabled in the device settings.
and press the [SET] button on the control unit for around 5 seconds to delete all
] button. If necessary, press the button several times
and briefly press the [SET] button on the control unit to delete
30