3File Dropping - Barco IQ PRO R210L Manual Del Usuario

How to select an existing projector by its location ?
Can be useful when the projectorname is not known.
1. Click on the three suspension points to open the projector selection dialogbox, imagen 15-54
2. Open the listbox and select the location (imagen 15-57)
The projectorname is filled in
3. Click on Connect
Following message is displayed : "Connected to <projectorname>..."
Imagen 15-57
This is only possible if the location has been filled, the default value for location being "<New Location>"
If the projector is not found following message will be displayed : "Host not found"
If the projector is found but unable to respond ( projector disconnected from the network, server software not
running, ...) following message will be displayed : " Host found , but server inactive"
15.8.3 File dropping
File dropping
Dropping a file means sending it to the projector.
The projector can then react in different ways depending on the drop mode selected :
• launch file
• launch file and share
• store file on the projector
What is File launching ?
Launch files: a file stored on the BarcoIQ PC or on the network can be accessed from a local PC (via the network) or from the
projector PC itself. Launching a file means "sending and starting up" a file (using the required software).
A PowerPoint file can be launched on your PC and projected in another place (the required MS PowerPoint software must be installed
on the BarcoIQ PC.
The file will only be projected if the "iQ PC" is selected in the source selection.
How to set the drop mode ?
1. Click on the arrow to pull down the installation menu
2. Click on the three suspension points access the dropmode dialogbox,imagen 15-53
Véase imagen 15-58.
3. Click on one of the three modes
R5976694S IQ PRO R210L/350/500 20122003
15. Red iQ
155