Attaching Embroidery Unit; Removing Embroidery Unit - Singer CE-250 Manual De Instrucciones

ATTACHING EMBROIDERY UNIT

Always be sure to turn off power to machine
before installing embroidery unit.
CAUTION
1. Turn off power to machine.
Remove connector cap from machine.
* Re-install connector cap before using machine for
general sewing.
2. Slide the embroidery unit onto machine fitting connectors
on the machine and embroidery unit. Slide the embroidery
unit as far as it will go until it clicks into place.
Hold handle of embroidery unit and pull it toward the left
direction, and check that embroidery unit does not detach.
Note:
If embroidery unit is not securely installed, the finished
e m b r o i d e r y m a y b e d i s t o r t e d . M a k e s u r e t h a t t h e
embroidery unit is pushed in as far as it will go.
Don't push the carriage nor put strong pressure
on it when attaching or using the embroidery unit
or otherwise it may result in the damage of the
CAUTION
embroidery unit.

REMOVING EMBROIDERY UNIT

Always be sure to turn off power to machine
before installing embroidery unit.
CAUTION
* Turn off power to machine.
* Remove embroidery hoop from machine.
(Refer to pages 82 - 83.)
1. Holding handle of embroidery unit, carefully slide toward
the left while pressing release lever.
Note:
Do not pull carriage when removing embroidery unit.
2. Insert the tab at the bottom of connector cap first, and
push in the top of the connector cap with your finger as
illustrated.
74
1
Carriage
2
Chariot
Carro
Handle
Poignée
Mango
1
Handle
2
Poignée
Mango
Connector cap
Couvercle de connecteur
Tapa de conector
Tab
Languette
Lengüeta
Connector cap
Couvercle de connecteur
Tapa de conector
Connector
Connecteur
Conector
Release lever
Support de cerceau
Palanca de liberación
Release lever
Support de cerceau
Palanca de liberación