Maintenance And Service; Maintenance And Cleaning - Skil 3310 Manual De Instrucciones

Setting the Standard Bevel Angle 45°
(Vertical1
– Bring the power tool into the working position.
– Turn the saw table
– Release the clamping lever
arm leftward to the stop (45°) by the handle 2.
Checking: (see figure Q1)
– Set an angle gauge to 45° and place it on the
saw table 6.
The leg of the angle gauge must be flush with the
saw blade 33 over the complete length.
Adjusting: (see figure Q2)
– Loosen the lock nut of the stop screw
a commercial box-end or open-end spanner
(size 13 mm).
– Screw the stop screw in or out until the leg of
the angle gauge is flush with the saw blade
over the complete length.
– Retighten the clamping lever
– Afterwards, retighten the lock nut of the stop
screw 18 again.
In case the angle indicator 38 is not in a line with
the 45° mark of the scale 41, firstly check the 0°
setting for the bevel angle and the angle indicator
again. Then repeat the adjustment of the 45° bevel
angle.
Transport
– Bring the machine into the transport position.
– Carry the machine by the transport handle
or hold it by the recessed grips 15 on the sides
of the saw table.
When transporting the power tool, use only
the transport devices and never use the
protective devices.
6 until it engages at 0°.
19 and tilt the tool
18 using
19 again.

Maintenance and Service

Maintenance and Cleaning

u Before any work on the machine itself, pull the
mains plug.
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an after-sales service
centre for Bosch power tools.
In all correspondence and spare parts order,
please always include the 10-digit article number
given on the type plate of the machine.
Cleaning
For safe and proper working, always keep the
power tool and its ventilation slots clean.
The retracting blade guard must always be able to
move freely and retract automatically. Therefore,
always keep the area around the retracting blade
guard clean.
Remove dust and chips after each working
procedure by blowing out with compressed air or
with a brush.
Clean the torsion Spring 20 regularly.
GUARANTEE / ENVIRONMENT
• Always keep tool and cord clean (especially the
ventilation slots)
! do not attempt to clean ventilation slots
by inserting pointed objects through
openings
23
! disconnect the plug before cleaning
• This SKIL product is guaranteed in accordance
with statutory/country-specific regulations;
damage due to normal wear and tear, overload
or improper handling will be excluded from the
guarantee
• In case of a complaint, send the tool
undismantled together with proof of purchase to
your dealer or the nearest SKIL service station
• Symbol
for disposing occurs
52
will remind you of this when the need