Desktop Mounting - Mettler Toledo IND780 Manual De Instalación

IND780 Installation Manual
panel is approximately 40 degrees from vertical, and reversible (angled up or
down).

Desktop Mounting

If the IND780 terminal is to be placed on a flat surface, the four rubber feet
included with the terminal should be adhered to the bottom of the enclosure to
prevent sliding. Peel each foot from the protective paper and press it onto one
corner of the bottom of the enclosure, as shown in Figure 2-6.
Preparation for Wall Mounting
An optional wall bracket kit is available for wall mounting the IND780 harsh
enclosure to a vertical surface. To prepare the enclosure for wall mounting, follow
these steps:
1. Establish orientation of enclosure (above or below eye level)
2. Install enclosure on brackets
3. Mark attachment points
4. Install mounting hardware
5. Mount terminal hardware
2-6
Figure 2-6: Rubber Feet for Desktop Mounting