Option Board Cabling - Mettler Toledo IND780 Manual De Instalación

IND780 Installation Manual
When using a clamp type ferrite, a loop can be made in the cable and the ferrite
snapped over the spot where the cable overlaps itself. Either the complete cable or
individual wires can be wrapped through the ferrite.
Wrapping should be done as close to the enclosure as possible.

Option Board Cabling

In order to prevent electromagnetic interference, when installing option boards
(especially Analog Load Cell boards) in the terminal, twist the loose wires together,
as shown in Figure 2-18, before attaching the green connector to the board.
2-12
Figure 2-15: Ferrite Core on Panel Mount Power Cord
Figure 2-16: Ferrite Core on Analog Load Cell Cable
Figure 2-17: Installing Clamp Ferrite
Figure 2-18: Option Board Wires Twisted