General Information - Würth EN 358 Instrucciones De Uso

Approved use
Exercise caution during use
Danger to life
Additional fall protection necessary

General information

Depending on length and classification, this product (1.1-1.5) can be
used as a mobile fall arrest device and/or as a work positioning- or
restraint lanyard. Check the classification on the rope and observe the
relevant section in the instructions. The systems must only be used by
persons trained in their use and who are also physically able to do so.
An effective rescue plan must always be available.
The components of the complete system must not be used individually
or replaced with other, possibly uncertified products. The fall arrest
device is only ever to be used with the rope supplied.
Only ever use the system as intended.
The mobile fall arrest device must always be attached to the fall arrest
attachment point marked 'A' on the safety harness (e.g. EN 361).
(2.1-2.3). The work positioning lanyard can be used for restraint or
positioning (work positioning).
When using, pay particular attention to sharp edges, the direction of
the rope and anything else which could da mage the rope or mobile
fall arrest device (2.6 + 2.7).
Ensure all carabiners are fully locked (3.4 + 3.5).
Before use, all instructions provided with the product must be read
and understood.
Service life depends on frequency of use and environmental
conditions.
1.) Definitions
1.) Flexible suspension material Ø 12 mm
2.) Rope adjuster/mobile fall arrest device
3. + 4.) Connector
5.) Sewn terminations/end knots
Instructions for use
11