Setting The Threaded Mandrel Length „X; Adjusting Setting Force - Gesipa FireBird Pro Manual De Instrucciones

GB
3.2 Setting the threaded mandrel length „X"
• Loosen lock nut 3
• Set the threaded mandrel length „X" to the blind rivet nut length by turning the nosepiece
(Fig. 4).
• Fully utilise the thread depth of closed blind rivet nuts (Fig. 4).
• Lock the nosepiece 2 against being turned with lock nut 3 using double open-ended
spanners (WAF 24/27).
3.3

Adjusting setting force

The FireBird Pro / FireBird
®
blind rivet nut size (e.g. M5). This ensures that all blind rivet nuts of certain dimensions (e.g.
M5) but with differing nut lengths (e.g. M5 x 11.5 and M5 x 13.5) can always be set precisely
as intended into materials of varying thicknesses.
The setting force is adjusted as follows:
1. The setting force value is selected using the setting-force chart included.
Excerpt from the setting-force chart:
M3
Alu 1
Steel 10
Stainless
15
steel
The right numerical value can be selected on the setting-force chart according to the nut sizes
and the nut materials. (e.g. M5 – steel > value for setting force 55)
2. After loosening locking screw 5 and removing cover 6, the value derived from the setting-
force chart is indicated on the riveting tool display 7 by pressing the plus/minus buttons. Pres-
sing the plus button will increase the numerical value. Pressing the minus button will reduce
the numerical value. If a button is held down for longer than one second, the numerical value
is modified in increments of 10.
24
Pro GE is adjusted to a setting force suitable for the respective
®
M4 M5
15 25
35 55
55 70
M6
50
80
85