Tabla de contenido
Publicidad
3.4.2 Wheel installation on ø32 fork with a 20 mm diameter
through-hole axle
DIRT JUMPER
For optimum fork performance, please follow the instructions below
when installing the wheel:
•
Place the wheel in between each fork.
•
Align the center of the wheel with each wheel axle clamp (see
3A of Picture 3).
•
Insert the axle through the wheel axle clamp of the right fork,
through the wheel, and through the wheel axle clamp of the left
fork (see 3A of Picture 3).
•
Tighten the axle to the required torque (
Allen key to the axle caps (see 3B of Picture 3).
•
Check for the proper fork-wheel alignment. To do this, begin by
fully compressing the fork a few times. The wheel should not
make contact with, or come close to any portion of the fork. Then
lift the front of the bicycle and spin the wheel a few times to verify
the correct alignment with the disk brake. The wheel should not
wobble from side to side or up and down. Check the owner's
manual of the brake system for the proper specifi cations.
•
Tighten the screw positioned on each wheel axle clamp to the required
torque (6±1 Nm) using a 4 mm Allen key (see 3C of Picture 3).
15±1 Nm
6 mm
6±1 Nm
4 mm
3C
Picture 3 - Wheel install on ø32 fork with a 20mm diameter through-hole axle
DJ COMP
15±1 Nm) using a 6 mm
3A
3B
3C
6±1 Nm
4 mm
3.4.3 Wheel installation on ø35/ø38 forks with a 20 mm
diameter through-hole axle
For optimum fork performance, please follow the instructions below
when installing the wheel:
•
Place the wheel in between each fork.
•
Align the center of the wheel with each wheel axle clamp (see
4A of Picture 4).
•
Insert the axle through the wheel axle clamp of the right fork,
through the wheel, and then screw it into the wheel axle clamp
of the left fork (see 4A of Picture 4).
•
Tighten the axle to the required torque (
Allen key to the caps of the axle (see 4B of Picture 4).
•
Check for the proper fork-wheel alignment. To do this, begin by
fully compressing the fork a few times. The wheel should not
make contact with, or come close to any portion of the fork. Then
lift the front of the bicycle and spin the wheel a few times to verify
the correct alignment with the disk brake. The wheel should not
wobble from side to side or up and down. Check the owner's
manual of the brake system for the proper specifi cations.
•
Tighten the screws positioned on each wheel axle clamp to the
required torque (6±1 Nm), with a "1-2-1" sequence, using a 4mm
Allen key (see 4C of Picture 4).
15±1 Nm
6 mm
6±1 Nm
4C
4 mm
4C
Picture 4 - Wheel install on ø35/ø38 forks with a 20 mm diameter through hole axle
888
15±1 Nm) using a 6mm
4A
4B
6±1 Nm
4 mm
23
Publicidad
Tabla de contenido
